Menu
No attachments, accessories, dies, or shell holders needed to catch spent primers.
The 0.06" Universal Pin, available for purchase, deprimes all major cases.
Freedom from the reloading bench. Deprime and sort cases simultaneously.
Machined from 6061 grade aluminum with a black anodized finish.
New primers seat properly with a clean primer pocket.
Fits most pistol and rifle cases, including Lapua cases, if you purchase the 0.06" pin.
Simply invert the deprimer over the trash container when squeezing the lever shut. The primer falls directly into the container!
Sort cases directly after depriming. Simply release the lever over your container for deprimed cases.
The Harvey Deprimer is portable and controls the ejection of the deprimer, allowing you to deprime while sitting down somewhere comfortable.
Weight: 11 ounces
Outside Length: 5 inches
Outside Width: 1 inch
Depriming pin diameter: .07 inch or .06 inch
Made from hardened steel, heat-treated to increase strength, and stress-tested with thousands of rounds of ammunition without incident.
Recommended for military crimped cases, specifically older (1940-1960) cases that also have a waterproof seal. Made from hardened steel. 0.069″ in diameter.
Fits most modern cases, including Lapua cases with a narrow flash hole. Not recommended for military crimped cases. Made from hardened steel. 0.059” in diameter.
Depriming facilitates a clean reload. Grit and grime from your pocket fall into your press when cases are not primed before cleaning. This is why your press needs cleaning after reloading. New primers seat properly with a clean primer pocket.
Left case: Cleaned then deprimed
Right case: Deprimed then cleaned
These cases were cleaned before being deprimed. You can see the grit and grime that comes out of the primer pocket.
The Harvey Deprimer works with well with any pistol and rifle rounds from a 9mm to a 408 CheyTac.
Universal Hand-Held Deprimer. Machined from 6061 grade aluminum with a black anodized finish.
Comes with
0.06" Universal Pin
and
0.07″ Standard Pin
Recommended for military crimped cases as well as most modern rifle and pistol cases.
Made from hardened steel.
.069” in diameter
Recommended for Lapua and Peterson cases with narrow flash hole. Not recommended for military crimped cases. Made from hardened steel.
.059” in diameter
2880 SW Ferry Street
Albany, OR 97322
(541) 401-1835
Valid August 30, 2024 Thru September 2, 2024